M100 Spring Airsoft Gun Sniper Rifle Owner's Manual

(Always set the safety lever to safe position before firing)

When you are not firing the gun or during storage, always set the selector to the Safe position and attach the protective cap to the muzzle.

When the safety lever is set to the "On" position, the trigger will not move. Please do not pull the trigger, otherwise you may damage the gun.

When the safety lever is set to the "Off" position, it is ready for shooting.

The gun will fire when the trigger is pulled.

Installation

Always set the magazine upwards. First hook the hook in the front of the magazine and then press in the rear of the magazine until a sound of "click" is heard.

Removing the Magazine

Press the magazine release lever to remove the magazine.

Caution

Be sure that the safety lever is set to the Safety position and don't place your finger on the trigger except when you are ready for shooting.

Load BB's into Speedloader

Open the Speedloader Cap. Insert 6 mm BB'S into the Speedloader.

Press the Rod Release button to release the Spring Rod.

Insert Speedloader into the magazine and pump Spring Rod until magazine is full.

The bolt retracts at the same time the operating rod is pulled.
To fire the gun, pull back Operating Rod all the way back, until a "click" is heard, then release.
Make sure the Safety release is in "Off" position. The gun is now ready for firing.
Pull Trigger.
Replace Safety release to "On" position when the gun is not in use.

Warning. Caution
Be careful not to put your finger in the bolt as it will close quickly when the operating rod is released.

Elevation adjustment

Turning counterclockwise lowers the bullet hitting point.

Turning clockwise raises the bullet hitting point.

Turning the elevations adjustment dial will move the bullet hitting point to the uppers or lower.

Windage adjustment

Turning clockwise moves the bullet hitting point to the left.

Turning counterclockwise moves the bullet hitting point to the right.

Turning the windage adjustment dial will move the bullet hitting point to the left or to the right.

How to Aim

Look through from the front sight to the hole of the rear sight, and aim at the center of the target.

How to hold

Press the butt plate against slightly inside of the shoulder joint and put your cheek on the stock. Aim at the center of the target as shown in the figures.

Be careful not to put your fingers in the moving parts.

Maintenance when bull speed becomes low

1. Apply Oil as shown below, using the cleaning rod and oiled cotton cloth. Insert cleaning rod into barrel.
2. After completeing cleaning, use the cleaning rod (with cotton) as shown below to Remove excess oil.

Caution
Always turn the hop up lever completely down before inserting Cleaning Rod.
It is difficult to insert the rod if you hold the rod at the end.

Removing Clogged Bullets (Set the Safety button to ON and remove the magazine beforehand.)

1. Remove the Magazine

Make sure to clean the barrel chamber whenever bullets are removed.

When bullets are clogged, immediately stop operation, remove clogged bullets and then restart operation of the air gun. (If operation is continued with bullets being clogged, the mechanism may be damaged.)

Be careful during maintenance, as the inside chamber is precisely designed and can be damaged easily. Use of a hard brush may damage the hop chamber packing.