UTG MK23 Navy Spring Pistol Owner's Manual

To set the Safety/Fire Selector on the "Safe" position, push the selector vertically all the way up(Fig 2.1)

To set the Safety/Fire Selector on the "Fire position", push the selector vertically all the way down(Fig 2.2)

Warning: Always use UTG Premium Precision Ground 6mm BB Pellets for accuracy and safety. Never re-use pellets.

Tip: For the magazine to work best with this pistol, do not load more than 26 pellets. If the pistol is cocked with an overloaded magazine, damage may occur to the guide rod and other internals. The easiest way to avoid overload is to fill the magazine to maximum capacity (27 BBs) and then remove one BB.

Make sure to set the Safety/Fire selector on the "Safe" position

Hold and disengage the magazine by pressing the Magazine Release Lever. (Fig 3.1)

Push 6mm pellets into the magazine through the Pallet Drop. (Fig 3.2)

Insert the loaded magazine back into the pistol.

Align and screw the Mock Flash Suppressor into the Muzzle (Fig 4.1)

Set Fire/Safety Lever to the "Fire" position. (Fig 5.1)

Pull the slide rearward all the way until it clicks, and push it back to the original position to complete cocking in one continuous movement.

Hold the gun firmly and aim the airsoft pistol at your target. Pull the trigger to fire.

Keep the airsoft pistol in clean condition.

Regularly clean the barrel with a soft cleaning rod.

Never look into the barrel with bare eyes.

Never point the gun to another person within shooting range.

Do not shoot at any target with hard surface within close range. Ricocchet pellets may injure yourself.

Do not brandish in public, do not alter the coloration and warning-such an action is dangerous and may be a crime.