| Spring Powered Hop-up System | |
|
|
|
| Load the BB bullet into the cartiridge as shown, making sure it is put into the cartridge completely in flat. | |
| back to top | |
|
|
| Push the latch forward in the direction of the arrow, then turn out the cylinder as shown. | |
| back to top | |
|
After the 6 cartridges are loaded, return to the cylinder to the right position. Press down here, making sure the cylinder locks into position. |
| back to top | |
|
When the safety latch is pushed back, the hammer can't be pressed back, but trigger and cylinder can still move. While the hammer is back, the safety device is useless. |
| back to top | |
|
Push the hammer until it clicks as shown. Don't touch the trigger until ready to fire. While pressing the hammer, the cylinder will move to the right position and lock. If it dosn't lock adjust it. Press the trigger to fire. Don't put your finger on the hammer. |
| back to top | |
|
Pull out the cylinder after firing, and use the extractor rod to remove the cartridge. |
| back to top | |
|
The rear sight can be adjusted as shown. |
| back to top | |
|
Be sure to wear shooting glasses or Goggle when shooting. Put the gun beyond the reach of kids. DO NOT peep at the muzzle. DO NOT aim at people even if it is unloaded. DO NOT touch the trigger until the moment of shooting. After making sure that there is nobody nearby. Avoid a rough operation. When the gun is not in use, remove the magazine and unload BB pellets. |
| back to top |